Trying 127.0.0.1... Connected to 127.0.0.1. Escape character is '^]'. �� ARM V2M-Juno Boot loader v1.0.0 HBI0262 build 2068 MBbios update in progress DO NOT SWITCH OFF... Device programmed: 1%Device programmed: 3%Device programmed: 4%Device programmed: 6%Device programmed: 7%Device programmed: 9%Device programmed: 10%Device programmed: 12%Device programmed: 14%Device programmed: 15%Device programmed: 17%Device programmed: 18%Device programmed: 20%Device programmed: 21%Device programmed: 23%Device programmed: 25%Device programmed: 26%Device programmed: 28%Device programmed: 29%Device programmed: 31%Device programmed: 32%Device programmed: 34%Device programmed: 35%Device programmed: 37%Device programmed: 39% MBbios update complete. ARM V2M_Juno Firmware v1.5.1 Build Date: Apr 3 2019 Time : 00:00:00 Date : 01:01:2000 Press Enter to stop auto boot... Powering up system... Switching on ATXPSU... PMIC RAM configuration (pms_v103.bin)... MBtemp : 36 degC Configuring motherboard (rev B, var A)... IOFPGA image \MB\HBI0262B\io_b118.bit IOFPGA config: PASSED OSC CLK config: PASSED Configuring SCC registers... Writing SCC 0x00000054 with 0x0007FFFE Writing SCC 0x0000005C with 0x00FE001E Writing SCC 0x00000100 with 0x003F1000 Writing SCC 0x00000104 with 0x0001F300 Writing SCC 0x00000108 with 0x00371000 Writing SCC 0x0000010C with 0x0001B300 Writing SCC 0x00000118 with 0x003F1000 Writing SCC 0x0000011C with 0x0001F100 Writing SCC 0x000000F8 with 0x0BEC0000 Writing SCC 0x000000FC with 0xABE40000 Writing SCC 0x0000000C with 0x000000C2 Writing SCC 0x00000010 with 0x000000C2 Peripheral ID0:0x000000AD Peripheral ID1:0x000000B0 Peripheral ID2:0x0000000B Peripheral ID3:0x00000000 Peripheral ID4:0x0000000D Peripheral ID5:0x000000F0 Peripheral ID6:0x00000005 Peripheral ID7:0x000000B1 Programming NOR Flash PCIE clock configured... Testing motherboard interfaces (FPGA build 118)... SRAM 32MB test: PASSED LAN9118 test: PASSED ERROR: SMC USB SRAM mode lock SMC USB test: FAILED KMI1/2 test: PASSED MMC test: PASSED PB/LEDs test: PASSED FPGA UART test: PASSED PCIe init test: PASSED MAC addrs test: PASSED SMC MAC address 0002-F700-584D Setting HDMI0 mode for SVGA. Setting HDMI1 mode for SVGA. SoC SMB clock enabled. Testing SMB clock... SMB clock running Releasing system resets... UART0 set to SoC UART0 UART1 set to SoC UART1 NOTICE: Booting Trusted Firmware NOTICE: BL1: v2.1(release):v2.2-rc0 NOTICE: BL1: Built : 02:01:47, Apr 13 2022 NOTICE: BL1: Booting BL2 NOTICE: BL2: v2.1(release):v2.2-rc0 NOTICE: BL2: Built : 02:01:49, Apr 13 2022 NOTICE: BL1: Booting BL31 NOTICE: BL31: v2.1(release):v2.2-rc0 NOTICE: BL31: Built : 02:01:52, Apr 13 2022 U-Boot 2022.04-00567-gb2a22b2c9f-dirty (Apr 14 2022 - 01:11:52 +0100) vexpress_aemv8a DRAM: 8 GiB PCIe XR3 Host Bridge enabled: x4 link (Gen 2) Core: 21 devices, 8 uclasses, devicetree: board Flash: 64 MiB Loading Environment from Flash... *** Warning - bad CRC, using default environment In: serial@7ff80000 Out: serial@7ff80000 Err: serial@7ff80000 Net: eth0: ethernet@200000000 Hit any key to stop autoboot: 1  0 VExpress64# setenv autoload no setenv autoload no VExpress64# setenv initrd_high 0xffffffffffffffff setenv initrd_high 0xffffffffffffffff VExpress64# setenv fdt_high 0xffffffffffffffff setenv fdt_high 0xffffffffffffffff VExpress64# dhcp dhcp smc911x: detected LAN9118 controller smc911x: phy initialized smc911x: MAC 00:02:f7:00:58:4d BOOTP broadcast 1 BOOTP broadcast 2 BOOTP broadcast 3 BOOTP broadcast 4 BOOTP broadcast 5 *** Unhandled DHCP Option in OFFER/ACK: 42 *** Unhandled DHCP Option in OFFER/ACK: 42 DHCP client bound to address 192.168.56.208 (3782 ms) smc911x: MAC 00:02:f7:00:58:4d VExpress64# setenv serverip 192.168.56.230 setenv serverip 192.168.56.230 VExpress64# tftp 0x80200000 205986/tftp-deploy-ek1y3cw2/kernel/uImage tftp 0x80200000 205986/tftp-deploy-ek1y3cw2/kernel/uImage smc911x: detected LAN9118 controller smc911x: phy initialized smc911x: MAC 00:02:f7:00:58:4d Using ethernet@200000000 device TFTP from server 192.168.56.230; our IP address is 192.168.56.208 Filename '205986/tftp-deploy-ek1y3cw2/kernel/uImage'. Load address: 0x80200000 Loading: *################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################# 1.5 MiB/s done Bytes transferred = 19565120 (12a8a40 hex) smc911x: MAC 00:02:f7:00:58:4d VExpress64# tftp 0x8fe00000 205986/tftp-deploy-ek1y3cw2/ramdisk/ramdisk.cpio.gz.uboot tftp 0x8fe00000 205986/tftp-deploy-ek1y3cw2/ramdisk/ramdisk.cpio.gz.uboot smc911x: detected LAN9118 controller smc911x: phy initialized smc911x: MAC 00:02:f7:00:58:4d Using ethernet@200000000 device TFTP from server 192.168.56.230; our IP address is 192.168.56.208 Filename '205986/tftp-deploy-ek1y3cw2/ramdisk/ramdisk.cpio.gz.uboot'. Load address: 0x8fe00000 Loading: *################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ############# 1.2 MiB/s done Bytes transferred = 11638608 (b19750 hex) smc911x: MAC 00:02:f7:00:58:4d VExpress64# setenv initrd_size ${filesize} setenv initrd_size ${filesize} VExpress64# tftp 0x8fc00000 205986/tftp-deploy-ek1y3cw2/dtb/juno.dtb tftp 0x8fc00000 205986/tftp-deploy-ek1y3cw2/dtb/juno.dtb smc911x: detected LAN9118 controller smc911x: phy initialized smc911x: MAC 00:02:f7:00:58:4d Using ethernet@200000000 device TFTP from server 192.168.56.230; our IP address is 192.168.56.208 Filename '205986/tftp-deploy-ek1y3cw2/dtb/juno.dtb'. Load address: 0x8fc00000 Loading: *## 3.9 KiB/s done Bytes transferred = 23301 (5b05 hex) smc911x: MAC 00:02:f7:00:58:4d VExpress64# setenv bootargs 'console=ttyAMA0,115200n8 root=/dev/nfs rw nfsroot=192.168.56.230:/var/lib/lava/dispatcher/tmp/205986/extract-nfsrootfs-msaadz35,tcp,hard,vers=3 earlycon=pl011,0x7ff80000 ip=dhcp' setenv bootargs 'console=ttyAMA0,115200n8 root=/dev/nfs rw nfsroot=192.168.56.230:/var/lib/lava/dispatcher/tmp/205986/extract-nfsrootfs-msaadz35,tcp,hard,vers=3 earlycon=pl011,0x7ff80000 ip=dhcp' VExpress64# bootm 0x80200000 0x8fe00000 0x8fc00000 bootm 0x80200000 0x8fe00000 0x8fc00000 ## Booting kernel from Legacy Image at 80200000 ... Image Name: Image Type: AArch64 Linux Kernel Image (uncompressed) Data Size: 19565056 Bytes = 18.7 MiB Load Address: 80200000 Entry Point: 80200000 Verifying Checksum ... OK ## Loading init Ramdisk from Legacy Image at 8fe00000 ... Image Name: Image Type: AArch64 Linux RAMDisk Image (uncompressed) Data Size: 11638544 Bytes = 11.1 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 8fc00000 Booting using the fdt blob at 0x8fc00000 Loading Kernel Image Using Device Tree in place at 000000008fc00000, end 000000008fc08b04 Starting kernel ...