connecting to NetworkSerialPort(target=Target(name='meson-g12b-odroid-n2', env=None), name='USBSerialPort', state=, avail=True, host='nuc-2', port=54853, speed=115200, protocol='rfc2217') calling microcom -s 115200 -t nuc-2:54853 connected to 192.168.0.2 (port 54853) Escape character: Ctrl-\ Type the escape character to get to the prompt. G12B:BL:6e7c85:7898ac;FEAT:E0F83180:2000;POC:F;RCY:0;EMMC:0;READ:0;CHK:1F;READ:0;CHK:1F;READ:0;CHK:1F;SD?:0;SD:0;READ:0;0.0 bl2_stage_init 0x01 bl2_stage_init 0x81 hw id: 0x0000 - pwm id 0x01 bl2_stage_init 0xc1 bl2_stage_init 0x02 no sdio debug board detected L0:00000000 L1:00000703 L2:00008067 L3:04000000 B2:00002000 B1:e0f83180 TE: 389771 BL2 Built : 17:21:55, Nov 19 2019. g12b gfa91ad3 - luan.yuan@droid15-sz Board ID = 3 Set A53 clk to 24M Set A73 clk to 24M Set clk81 to 24M A53 clk: 1200 MHz A73 clk: 1200 MHz CLK81: 166.6M smccc: 00063a6d DDR driver_vesion: LPDDR4_PHY_V_0_1_21 build time: Nov 19 2019 17:21:51 board id: 3 Load FIP HDR from SD, src: 0x00010200, des: 0xfffd0000, size: 0x00004000, part: 0 Get wrong ddr fw magic! Error!! fw parse done Load ddrfw from SD, src: 0x00060200, des: 0xfffd0000, size: 0x0000c000, part: 0 Load ddrfw from SD, src: 0x00038200, des: 0xfffd0000, size: 0x00004000, part: 0 PIEI prepare done fastboot data verify result: 255 Cfg max: 12, cur: 1. Board id: 255. Force loop cfg DDR4 probe ddr clk to 1320MHz Load ddrfw from SD, src: 0x00014200, des: 0xfffd0000, size: 0x0000c000, part: 0 dmc_version 0000 Check phy result INFO : End of initialization INFO : End of read enable training INFO : End of fine write leveling INFO : End of read dq deskew training INFO : End of MPR read delay center optimization INFO : End of Write leveling coarse delay INFO : End of write delay center optimization INFO : End of read delay center optimization INFO : End of max read latency training INFO : Training has run successfully! 1D training succeed Load ddrfw from SD, src: 0x00020200, des: 0xfffd0000, size: 0x0000c000, part: 0 Check phy result INFO : End of initialization INFO : End of 2D read delay Voltage center optimization INFO : End of 2D write delay Voltage center optimization INFO : Training has run successfully! soc_vref_reg_value 0x 00000034 00000031 00000031 00000030 00000031 00000031 0000002f 00000030 00000032 0000002e 00000031 00000031 0000002c 00000032 0000002e 00000032 00000033 00000033 00000030 0000002f 00000030 0000002e 0000002e 00000032 0000002d 00000032 00000032 00000030 00000032 00000034 00000030 00000031 dwc_ddrphy_apb_wr((0<<20)|(2<<16)|(0<<12)|(0xb0):0001 dram_vref_reg_value 0x 00000017 2D training succeed aml_ddr_fw_vesion: LPDDR4_PHY_V_0_1_21 build time: Nov 19 2019 17:21:57 auto size-- 65535DDR cs0 size: 2048MB DDR cs1 size: 0MB DMC_DDR_CTRL: 0050002cDDR size: 2048MB cs0 DataBus test pass cs0 AddrBus test pass non-sec scramble use zero key ddr scramble enabled 100bdlr_step_size ps== 518 result report boot times 0Enable ddr reg access Load FIP HDR from SD, src: 0x00010200, des: 0x01700000, size: 0x00004000, part: 0 Load BL3X from SD, src: 0x0006c200, des: 0x0175c000, size: 0x0008c000, part: 0 0.0;M3 CHK:0;cm4_sp_mode 0 MVN_1=0x00000000 MVN_2=0x00000000 [Image: g12b_v1.1.3382-173caa3 2019-09-26 18:26:34 luan.yuan@droid15-sz] OPS=0x40 ring efuse init chipver efuse init 29 0a 40 00 01 19 1f 00 00 19 34 37 57 4e 4b 50 [0.018987 Inits done] secure task start! high task start! low task start! run into bl31 NOTICE: BL31: v1.3(release):f941450 NOTICE: BL31: Built : 20:36:07, Sep 24 2019 NOTICE: BL31: G12A normal boot! NOTICE: BL31: BL33 decompress pass ERROR: Error initializing runtime service opteed_fast U-Boot 2020.07 (Sep 16 2020 - 09:44:08 -0700) odroid-n2 Model: Hardkernel ODROID-N2 SoC: Amlogic Meson G12B (S922X) Revision 29:a (40:2) DRAM: 2 GiB MMC: sd@ffe05000: 0, mmc@ffe07000: 1 In: serial@3000 Out: serial@3000 Err: serial@3000 Net: Warning: ethernet@ff3f0000 (eth0) using random MAC address - 0e:be:63:60:4d:2c eth0: ethernet@ff3f0000 Hit any key to stop autoboot: 2  0 => setenv autoload no => setenv initrd_high 0xffffffff => setenv fdt_high 0xffffffff => dhcp Speed: 100, full duplex BOOTP broadcast 1 BOOTP broadcast 2 BOOTP broadcast 3 BOOTP broadcast 4 BOOTP broadcast 5 DHCP client bound to address 192.168.0.119 (4022 ms) => setenv serverip 192.168.0.2 => tftp 0x1080000 3895293/tftp-deploy-302vbe9d/kernel/Image Speed: 100, full duplex Using ethernet@ff3f0000 device TFTP from server 192.168.0.2; our IP address is 192.168.0.119 Filename '3895293/tftp-deploy-302vbe9d/kernel/Image'. Load address: 0x1080000 Loading: *################################################################# ############################################T ##T ################### ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ############## 1.4 MiB/s done Bytes transferred = 66032128 (3ef9200 hex) => tftp 0x13000000 3895293/tftp-deploy-302vbe9d/ramdisk/ramdisk.cpio.gz.uboot Speed: 100, full duplex Using ethernet@ff3f0000 device TFTP from server 192.168.0.2; our IP address is 192.168.0.119 Filename '3895293/tftp-deploy-302vbe9d/ramdisk/ramdisk.cpio.gz.uboot'. Load address: 0x13000000 Loading: *################################################################# ############################T ##################################### ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ########### 1.4 MiB/s done Bytes transferred = 33544487 (1ffd927 hex) => setenv initrd_size ${filesize} => tftp 0x1000000 3895293/tftp-deploy-302vbe9d/dtb/meson-g12b-odroid-n2.dtb Speed: 100, full duplex Using ethernet@ff3f0000 device TFTP from server 192.168.0.2; our IP address is 192.168.0.119 Filename '3895293/tftp-deploy-302vbe9d/dtb/meson-g12b-odroid-n2.dtb'. Load address: 0x1000000 Loading: *#### 1.5 MiB/s done Bytes transferred = 54519 (d4f7 hex) => setenv bootargs 'console=ttyAML0,115200n8 root=/dev/ram0 console_msg_format=syslog earlycon deferred_probe_timeout=60 ip=:::::eth0:dhcp' => booti 0x1080000 0x13000000 0x1000000 ## Loading init Ramdisk from Legacy Image at 13000000 ... Image Name: Image Type: AArch64 Linux RAMDisk Image (uncompressed) Data Size: 33544423 Bytes = 32 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 01000000 Booting using the fdt blob at 0x1000000 Loading Ramdisk to 7bf45000, end 7df428e7 ... OK ERROR: reserving fdt memory region failed (addr=5000000 size=300000) Loading Device Tree to 000000007bf34000, end 000000007bf444f6 ... OK Starting kernel ... "Synchronous Abort" handler, esr 0x96000010 "Synchronous Abort" handler, esr 0x96000010 elr: 0000000001002590 lr : 00000000010027b8 (reloc) elr: 000000007ff55590 lr : 000000007ff557b8 x0 : 00000000050fff50 x1 : 0000000000002383 x2 : 0000000002102a00 x3 : 0000000000000020 x4 : 0000000000000000 x5 : 0000000000000030 x6 : 000000007ffb62b9 x7 : 00000000050fff20 x8 : 00000000050ffde0 x9 : 0068000000000400 x10: 00000000ffffffd0 x11: 0000000000000008 x12: 00000000039a0000 x13: 00000000051d9ff8 x14: 000000007df43908 x15: 0000000000000008 x16: 0000000000000000 x17: 0000000000000000 x18: 000000007df50df0 x19: 00000000050fff50 x20: 00000000050fff50 x21: 000000007bf34000 x22: 0000000000000000 x23: 0000000000000710 x24: 0000000000000003 x25: 000000007df633f8 x26: 000000007ffcbeb0 x27: 0000000000000000 x28: 000000007df63800 x29: 00000000050ffee0 Code: a9025bf5 f9001bf7 f9400641 36000141 (f9407e83) Resetting CPU ...