[Enter `^Ec?' for help] m `f�| coreboot-9211c87 Fri Feb 9 21:48:12 UTC 2018 bootblock starting... ARM64: Exception handlers installed. ARM64: Testing exception ARM64: Done test exception PLL at 00000000ff750000: fbdiv=169, refdiv=3, postdiv1=2, postdiv2=1, vco=1352000 khz, output=676000 khz PLL at 00000000ff760080: fbdiv=99, refdiv=1, postdiv1=4, postdiv2=1, vco=2376000 khz, output=594000 khz PLL at 00000000ff760060: fbdiv=100, refdiv=1, postdiv1=3, postdiv2=1, vco=2400000 khz, output=800000 khz Backing address range [0000000000000000:0000008000000000) with new page table @00000000ff8e6000 Mapping address range [0000000000000000:0000000100000000) as cacheable | read-write | secure | device Mapping address range [00000000ff8c0000:00000000ff8f0000) as cacheable | read-write | secure | normal Backing address range [00000000c0000000:0000000100000000) with new page table @00000000ff8e7000 Backing address range [00000000ff800000:00000000ffa00000) with new page table @00000000ff8e8000 ADC reading 583, ID 8 PLL at 00000000ff760000: fbdiv=63, refdiv=1, postdiv1=1, postdiv2=1, vco=1512000 khz, output=1512000 khz I2C bus 0: 398584Hz (divh = 44, divl = 60) SF: Detected GD25LQ64C/GD25LB64C with sector size 0x1000, total 0x800000 VBOOT: Loading verstage. CBFS @ 20000 size 2e0000 CBFS: 'Master Header Locator' located CBFS at [20000:300000) CBFS: Locating 'fallback/verstage' CBFS: Found @ offset 19e00 size 852b coreboot-9211c87 Fri Feb 9 21:48:12 UTC 2018 verstage starting... ARM64: Exception handlers installed. ARM64: Testing exception ARM64: Done test exception SF: Detected GD25LQ64C/GD25LB64C with sector size 0x1000, total 0x800000 FMAP: Found "FMAP" version 1.0 at 300000. FMAP: base = 0 size = 800000 #areas = 22 FMAP: area RW_NVRAM found @ 5f0000 (65536 bytes) tpm_vendor_probe: ValidSts bit set(1) in TPM_ACCESS register after 1 ms I2C TPM 0:20 (chip type slb9645tt device-id 0x1A) TPM: Startup TPM: command 0x99 returned 0x0 TPM: Asserting physical presence TPM: command 0x4000000a returned 0x0 TPM: command 0x65 returned 0x0 TPM: flags disable=0, deactivated=0, nvlocked=1 setup_tpm():445: TPM: SetupTPM() succeeded TPM: tlcl_read(0x1007, 10) TPM: command 0xcf returned 0x0 out: cmd=0x87: 03 bf 87 00 00 00 04 00 08 20 8c ff in-header: 03 f1 00 00 04 00 00 00 in-data: 80 20 60 08 Phase 1 FMAP: area GBB found @ 301000 (913152 bytes) VB2:vb2_check_recovery() Recovery reason from previous boot: 0x0 / 0x0 Phase 2 Phase 3 FMAP: area GBB found @ 301000 (913152 bytes) VB2:vb2_report_dev_firmware() This is developer signed firmware FMAP: area VBLOCK_A found @ 400000 (8192 bytes) FMAP: area VBLOCK_A found @ 400000 (8192 bytes) VB2:vb2_verify_keyblock() Checking key block signature... FMAP: area VBLOCK_A found @ 400000 (8192 bytes) FMAP: area VBLOCK_A found @ 400000 (8192 bytes) VB2:vb2_verify_fw_preamble() Verifying preamble. Phase 4 FMAP: area FW_MAIN_A found @ 402000 (941824 bytes) VB2:vb2api_init_hash() HW crypto for hash_alg 2 not supported, using