Trying 127.0.0.1... Connected to 127.0.0.1. Escape character is '^]'. G12B:BL:6e7c85:7898ac;FEAT:E0F83180:2000;POC:F;RCY:0;EMMC:0;READ:0;CHK:1F;READ:0;CHK:1F;READ:0;CHK:1F;SD?:0;SD:0;READ:0;0.0 bl2_stage_init 0x01 bl2_stage_init 0x81 hw id: 0x0000 - pwm id 0x01 bl2_stage_init 0xc1 bl2_stage_init 0x02 no sdio debug board detected L0:00000000 L1:00000703 L2:00008067 L3:04000000 B2:00002000 B1:e0f83180 TE: 402840 BL2 Built : 06:17:13, Jun 28 2019. g12b gf0505d7-dirty - qi.duan@droid13 Board ID = 3 Set A53 clk to 24M Set A73 clk to 24M Set clk81 to 24M A53 clk: 1200 MHz A73 clk: 1200 MHz CLK81: 166.6M smccc: 00066dcf DDR driver_vesion: LPDDR4_PHY_V_0_1_14 build time: Jun 28 2019 06:17:09 board id: 3 Load FIP HDR from SD, src: 0x00010200, des: 0xfffd0000, size: 0x00004000, part: 0 fw parse done Load ddrfw from SD, src: 0x00060200, des: 0xfffd0000, size: 0x0000c000, part: 0 Load ddrfw from SD, src: 0x00038200, des: 0xfffd0000, size: 0x00004000, part: 0 PIEI prepare done fastboot data load fastboot data verify verify result: 255 Cfg max: 2, cur: 1. Board id: 255. Force loop cfg DDR4 probe ddr clk to 1320MHz Load ddrfw from SD, src: 0x00014200, des: 0xfffd0000, size: 0x0000c000, part: 0 Check phy result INFO : End of initialization INFO : End of read enable training INFO : End of fine write leveling INFO : End of read dq deskew training INFO : End of MPR read delay center optimization INFO : End of Write leveling coarse delay INFO : End of write delay center optimization INFO : End of read delay center optimization INFO : End of max read latency training INFO : Training has run successfully! 1D training succeed Load ddrfw from SD, src: 0x00020200, des: 0xfffd0000, size: 0x0000c000, part: 0 Check phy result INFO : End of initialization INFO : End of 2D read delay Voltage center optimization INFO : End of 2D write delay Voltage center optimization INFO : Training has run successfully! R0_RxClkDly_Margin==70 ps 6 R0_TxDqDly_Margi==82 ps 7 R1_RxClkDly_Margin==0 ps 0 R1_TxDqDly_Margi==0 ps 0 dwc_ddrphy_apb_wr((0<<20)|(2<<16)|(0<<12)|(0xb0):0001 2D training succeed auto size-- 65535DDR cs0 size: 2048MB DDR cs1 size: 2048MB DMC_DDR_CTRL: 00600024DDR size: 3928MB cs0 DataBus test pass cs1 DataBus test pass cs0 AddrBus test pass cs1 AddrBus test pass pre test bdlr_100_average==456 bdlr_100_min==456 bdlr_100_max==456 bdlr_100_cur==456 aft test bdlr_100_average==456 bdlr_100_min==456 bdlr_100_max==456 bdlr_100_cur==456 non-sec scramble use zero key ddr scramble enabled 100bdlr_step_size ps== 456 result report boot times 0Enable ddr reg access Load FIP HDR from SD, src: 0x00010200, des: 0x01700000, size: 0x00004000, part: 0 Load BL3X from SD, src: 0x0006c200, des: 0x0175c000, size: 0x00098400, part: 0 0.0;M3 CHK:0;cm4_sp_mode 0 E30HDR MVN_1=0x00000000 MVN_2=0x00000000 [Image: g12b_v1.1.3375-8f9c8a7 2019-01-24 10:44:46 guotai.shen@droid11-sz] OPS=0x40 ring efuse init chipver efuse init 29 0a 40 00 01 06 1e 00 00 19 34 37 57 4e 4b 50 [0.019859 Inits done] secure task start! high task start! low task start! run into bl31 NOTICE: BL31: v1.3(release):ab8811b NOTICE: BL31: Built : 15:03:31, Feb 12 2019 NOTICE: BL31: G12A normal boot! NOTICE: BL31: BL33 decompress pass ERROR: Error initializing runtime service opteed_fast U-Boot 2022.04-clabbe (Jun 21 2022 - 12:55:34 +0000) odroid-n2/n2-plus Model: Hardkernel ODROID-N2 SoC: Amlogic Meson G12B (S922X) Revision 29:a (40:2) DRAM: 3.8 GiB Core: 381 devices, 24 uclasses, devicetree: separate MMC: sd@ffe05000: 0, mmc@ffe07000: 1 Loading Environment from nowhere... OK In: serial Out: serial Err: serial Board variant: n2 Net: eth0: ethernet@ff3f0000 Hit any key to stop autoboot: 2  0 => setenv autoload no setenv autoload no => setenv initrd_high 0xffffffff setenv initrd_high 0xffffffff => setenv fdt_high 0xffffffff setenv fdt_high 0xffffffff => dhcp dhcp ethernet@ff3f0000 Waiting for PHY auto negotiation to complete....... done Speed: 1000, full duplex BOOTP broadcast 1 BOOTP broadcast 2 DHCP client bound to address 10.201.4.217 (286 ms) => setenv serverip 10.201.1.3 setenv serverip 10.201.1.3 => tftp 0x13000000 2190401/tftp-deploy-if3hvtwk/kernel/Image tftp 0x13000000 2190401/tftp-deploy-if3hvtwk/kernel/Image Speed: 1000, full duplex Using ethernet@ff3f0000 device TFTP from server 10.201.1.3; our IP address is 10.201.4.217 Filename '2190401/tftp-deploy-if3hvtwk/kernel/Image'. Load address: 0x13000000 Loading: *################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# #################### 11.9 MiB/s done Bytes transferred = 31773184 (1e4d200 hex) => tftp 0x6000000 2190401/tftp-deploy-if3hvtwk/ramdisk/ramdisk.cpio.gz.uboot tftp 0x6000000 2190401/tftp-deploy-if3hvtwk/ramdisk/ramdisk.cpio.gz.uboot Speed: 1000, full duplex Using ethernet@ff3f0000 device TFTP from server 10.201.1.3; our IP address is 10.201.4.217 Filename '2190401/tftp-deploy-if3hvtwk/ramdisk/ramdisk.cpio.gz.uboot'. Load address: 0x6000000 Loading: *################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ##### 11.8 MiB/s done Bytes transferred = 15328196 (e9e3c4 hex) => setenv initrd_size ${filesize} setenv initrd_size ${filesize} => tftp 0x9000000 2190401/tftp-deploy-if3hvtwk/dtb/meson-g12b-odroid-n2.dtb tftp 0x9000000 2190401/tftp-deploy-if3hvtwk/dtb/meson-g12b-odroid-n2.dtb Speed: 1000, full duplex Using ethernet@ff3f0000 device TFTP from server 10.201.1.3; our IP address is 10.201.4.217 Filename '2190401/tftp-deploy-if3hvtwk/dtb/meson-g12b-odroid-n2.dtb'. Load address: 0x9000000 Loading: *#### 5.4 MiB/s done Bytes transferred = 51210 (c80a hex) => setenv bootargs 'console=ttyAML0,115200n8 root=/dev/nfs rw nfsroot=10.201.1.3:/var/lib/lava/dispatcher/tmp/2190401/extract-nfsrootfs-puyn499o,tcp,hard console_msg_format=syslog earlycon ip=dhcp' setenv bootargs 'console=ttyAML0,115200n8 root=/dev/nfs rw nfsroot=10.201.1.3:/var/lib/lava/dispatcher/tmp/2190401/xatnrof-y49,phrcnoes_om=yl alc pdp >