Trying 127.0.0.1... Connected to 127.0.0.1. Escape character is '^]'. [ 0.000132] NOTICE: BL2: R-Car M3 Initial Program Loader(CA57) [ 0.004569] NOTICE: BL2: Initial Program Loader(Rev.1.0.23) [ 0.010184] NOTICE: BL2: PRR is R-Car M3 Ver.1.1 / Ver.1.2 [ 0.015720] NOTICE: BL2: Board is HiHope Rev.1.0 [ 0.020381] NOTICE: BL2: Boot device is QSPI Flash(40MHz) [ 0.025821] NOTICE: BL2: LCM state is CM [ 0.029803] NOTICE: BL2: DDR3200(rev.0.34) [ 0.041310] NOTICE: BL2: [COLD_BOOT] [ 0.047415] NOTICE: BL2: DRAM Split is 2ch [ 0.050109] NOTICE: BL2: QoS is default setting(rev.0.17) [ 0.055552] NOTICE: BL2: DRAM refresh interval 1.95 usec [ 0.060968] NOTICE: BL2: Lossy Decomp areas [ 0.065142] NOTICE: Entry 0: DCMPAREACRAx:0x80000540 DCMPAREACRBx:0x570 [ 0.072227] NOTICE: Entry 1: DCMPAREACRAx:0x40000000 DCMPAREACRBx:0x0 [ 0.079139] NOTICE: Entry 2: DCMPAREACRAx:0x20000000 DCMPAREACRBx:0x0 [ 0.086054] NOTICE: BL2: v1.5(release):7f126e2-dirty [ 0.091063] NOTICE: BL2: Built : 05:30:26, Feb 19 2019 [ 0.096250] NOTICE: BL2: Normal boot [ 0.099895] NOTICE: BL2: dst=0xe631ed00 src=0x8180000 len=512(0x200) [ 0.106379] NOTICE: BL2: dst=0x43f00000 src=0x8180400 len=6144(0x1800) [ 0.114107] NOTICE: BL2: dst=0x44000000 src=0x81c0000 len=65536(0x10000) [ 0.133025] NOTICE: BL2: dst=0x50000000 src=0x8640000 len=1048576(0x100000) [ 0.353285] NOTICE: BL2: Booting BL31 U-Boot 2018.09 (Feb 17 2019 - 22:58:22 +0000) CPU: Renesas Electronics R8A7796 rev 1.1/rev 1.2 Model: HOPERUN HiHope board based on r8a7796 DRAM: 3.9 GiB Bank #0: 0x048000000 - 0x0bfffffff, 1.9 GiB Bank #1: 0x600000000 - 0x67fffffff, 2 GiB MMC: sd@ee100000: 0, sd@ee160000: 1 Loading Environment from MMC... OK In: serial@e6e88000 Out: serial@e6e88000 Err: serial@e6e88000 Net: eth0: ethernet@e6800000 Hit any key to stop autoboot: 2  0 => setenv autoload no setenv autoload no => setenv initrd_high 0xffffffff setenv initrd_high 0xffffffff => setenv fsetenv f