Trying 127.0.0.1... Connected to 127.0.0.1. Escape character is '^]'. RomBOOT AT91Bootstrap 3.7.2-rc2-dirty (Tue 14 Apr 02:17:07 BST 2015) NAND: ONFI not supported NAND: Manufacturer ID: 0xec Chip ID: 0xda NAND: Disable On-Die ECC NAND: Press the recovery button (BP4) to recovery NAND: Using Software ECC NAND: Image: Copy 0x80000 bytes from 0x40000 to 0x21f00000 NAND: Done to load image U-Boot 2015.01 (Apr 14 2015 - 16:45:04) CPU: AT91SAM9G20 Crystal frequency: 18.432 MHz CPU clock : 396.288 MHz Master clock : 132.096 MHz DRAM: 64 MiB WARNING: Caches not enabled NAND: 256 MiB MMC: mci: 0 In: serial Out: serial Err: serial Net: macb0 Hit any key to stop autoboot: 3  0 U-Boot> setenv autoload no setenv autoload no U-Boot> setenv initrd_high 0xffffffff setenv initrd_high 0xffffffff U-Boot> setenv fdt_high 0xffffffff setenv fdt_high 0xffffffff U-Boot> dhcp dhcp macb0: Starting autonegotiation... macb0: Autonegotiation complete macb0: link up, 100Mbps full-duplex (lpa: 0xc1e1) BOOTP broadcast 1 BOOTP broadcast 2 BOOTP broadcast 3 BOOTP broadcast 4 BOOTP broadcast 5 DHCP client bound to address 192.168.56.84 (3787 ms) U-Boot> setenv serverip 192.168.56.230 setenv serverip 192.168.56.230 U-Boot> tftp 0x22100000 446240/tftp-deploy-bqck0dql/kernel/zImage tftp 0x22100000 446240/tftp-deploy-bqck0dql/kernel/zImage macb0: link up, 100Mbps full-duplex (lpa: 0xc1e1) Using macb0 device TFTP from server 192.168.56.230; our IP address is 192.168.56.84 Filename '446240/tftp-deploy-bqck0dql/kernel/zImage'. Load address: 0x22100000 Loading: *###################################################################################################################################################################################################################################################################################### 1.3 MiB/s done Bytes transferred = 4135176 (3f1908 hex) U-Boot> tftp 0x23000000 446240/tftp-deploy-bqck0dql/ramdisk/ramdisk.cpio.gz.uboot tftp 0x23000000 446240/tftp-deploy-bqck0dql/ramdisk/ramdisk.cpio.gz.uboot macb0: link up, 100Mbps full-duplex (lpa: 0xc1e1) Using macb0 device TFTP from server 192.168.56.230; our IP address is 192.168.56.84 Filename '446240/tftp-deploy-bqck0dql/ramdisk/ramdisk.cpio.gz.uboot'. Load address: 0x23000000 Loading: *###################################################################################################################################################################################################################################################################################################################################### 1.2 MiB/s done Bytes transferred = 4854649 (4a1379 hex) U-Boot> setenv initrd_size ${filesize} setenv initrd_size ${filesize} U-Boot> tftp 0x22000000 446240/tftp-deploy-bqck0dql/dtb/at91sam9g20ek.dtb tftp 0x22000000 446240/tftp-deploy-bqck0dql/dtb/at91sam9g20ek.dtb macb0: link up, 100Mbps full-duplex (lpa: 0xc1e1) Using macb0 device TFTP from server 192.168.56.230; our IP address is 192.168.56.84 Filename '446240/tftp-deploy-bqck0dql/dtb/at91sam9g20ek.dtb'. Load address: 0x22000000 Loading: *## 1.2 MiB/s done Bytes transferred = 19903 (4dbf hex) U-Boot> setenv bootargs ' root=/dev/nfs rw nfsroot=192.168.56.230:/var/lib/lava/dispatcher/tmp/446240/extract-nfsrootfs-skb6oi00,tcp,hard,vers=3 cma=0 ip=dhcp' setenv bootargs ' root=/dev/nfs rw nfsroot=192.168.56.230:/var/lib/lava/dispatcher/tmp/446240/extract-nfsrootfs-skb6oi00,tcp,hard,vers=3 cma=0 ip=dhcp' U-Boot> bootz 0x22100000 0x23000000 0x22000000 bootz 0x22100000 0x23000000 0x22000000 Kernel image @ 0x22100000 [ 0x000000 - 0x3f1908 ] ## Loading init Ramdisk from Legacy Image at 23000000 ... Image Name: Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 4854585 Bytes = 4.6 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 22000000 Booting using sing Device Tree in place at 22000000, end 22007dbe Starting kernel ... Booting Linux on physical CPU 0x0 Linux version 4.19.255-cip79 (KernelCI@build-j71180-arm-gcc-10-at91-dt-defconfig-9lbjk) (gcc version 10.2.1 20210110 (Debian 10.2.1-6)) #1 Tue Aug 23 04:44:18 UTC 2022 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=0005317f CPU: VIVT data cache, VIVT instruction cache OF: fdt: Machine model: Atmel at91sam9g20ek Memory policy: Data cache writeback Built 1 zonelists, mobility grouping on. Total pages: 16256 Kernel command line: root=/dev/nfs rw nfsroot=192.168.56.230:/var/lib/lava/dispatcher/tmp/446240/extract-nfsrootfs-skb6oi00,tcp,hard,vers=3 cma=0 ip=dhcp Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 51720K/65536K available (5703K kernel code, 186K rwdata, 1936K rodata, 236K init, 122K bss, 13816K reserved, 0K cma-reserved) Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xffc00000 - 0xfff00000 (3072 kB) vmalloc : 0xc48 lowmem : 0xc0000000 - 0xc4000000 ( 64 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .text : 0x(ptrval) - 0x(ptrval) (5705 kB) .init : 0x(ptrval) - 0x(ptrval) ( 236 kB) .data : 0x(ptrval) - 0x(ptrval) ( 187 kB) .bss : 0x(ptrval) - 0x(ptrval) ( 123 kB) NR_IRQS: 16, nr_irqs: 16, preallocated irqs: 16 clocksource: pit: mask: 0x7ffffff max_cycles: 0x7ffffff, max_idle_ns: 7234361498 ns Console: colour dummy device 80x30 console [tty0] enabled sched_clock: 32 bits at 128 Hz, resolution 7812500ns, wraps every 16777215996093750ns Calibrating delay loop... 197.44 BogoMIPS (lpj=770048) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) CPU: Testing write buffer coherency: ok Setting up static identity map for 0x20008400 - 0x2000847c devtmpfs: initialized clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 14931722236523437 ns futex hash table entries: 256 (order: -1, 3072 bytes) pinctrl core: initialized pinctrl subsystem NET: Registered protocol family 16 DMA: preallocated 256 KiB pool for atomic coherent allocations AT91: PM: standby: standby, suspend: ulp0 No ATAGs? gpio-at91 fffff400.gpio: at address (ptrval) gpio-at91 fffff600.gpio: at address (ptrval) gpio-at91 fffff800.gpio: at address (ptrval) pinctrl-at91 ahb:apb:pinctrl@fffff400: initialized AT91 pinctrl driver clocksource: tcb_clksrc: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 115749784805 ns AT91: Detected SoC: at91sam9g20, revision 1 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb i2c-gpio i2c-gpio-0: using lines 23 (SDA) and 24 (SCL) videodev: Linux video capture interface: v2.00 pps_core: LinuxPPS API ver. 1 registered pps_core: Software ver. 5.3.6 - Copyright 2005-2007 Rodolfo Giometti fffbc000.ssc mapping ok NET: Registered protocol family 10 Segment Routing with IPv6 sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver NET: Registered protocol family 17 Loading compiled-in X.509 certificates input: gpio_keys as /devices/platform/gpio_keys/input/input0 rtc-at91sam9 fffffd20.rtc: hctosys: unable to read the hardware clock IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready macb fffc4000.ethernet eth0: link up (100/Full) IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready Sending DHCP requests .., OK IP-Config: Got DHCP answer from 192.168.56.254, my address is 192.168.56.84 IP-Config: Complete: device=eth0, hwaddr=a6:72:4e:7e:7a:f8, ipaddr=192.168.56.84, mask=255.255.255.0, gw=192.168.56.254 host=192.168.56.84, domain=mayfield.sirena.org.uk, nis-domain=(none) bootserver=192.168.56.254, rootserver=192.168.56.230, rootpath= nameserver0=192.168.56.254 ntpserver0=50.205.244.22, ntpserver1=85.199.214.99 cfg80211: Loading compiled-in X.509 certificates for regulatory database cfg80211: Loaded X.509 cert 'sforshee: 00b28ddf47aef9cea7' ALSA device list: #0: wm8731 @ AT91SAMG20EK platform regulatory.0: Direct firmware load for regulatory.db failed with error -2 cfg80211: failed to load regulatory.db Freeing unused kernel memory: 236K This architecture does not have kernel memory protection. Run /init as init process Loading, please wait... Starting version 247.3-7 Begin: Loading essential drivers ... done. Begin: Running /scripts/init-premount ... done. Begin: Mounting root file system ... Begin: Running /scripts/nfs-top ... done. Begin: Running /scripts/nfs-premount ... done. IP-Config: eth0 hardware address a6:72:4e:7e:7a:f8 mtu 1500 DHCP IP-Config: eth0 complete (dhcp from 192.168.56.254): address: 192.168.56.84 broadcast: 192.168.56.255 netmask: 255.255.255.0 gateway: 192.168.56.254 dns0 .0.0.0 domain : mayfield.sirena.org.uk rootserver: 192.168.56.254 rootpath: filename : om ... done. Begin: Running /scripts/init-bottom ... done. systemd[1]: System time before build time, advancing clock. systemd[1]: Failed to find module 'autofs4' systemd[1]: Failed to mount tmpfs at /sys/fs/cgroup: No such file or directory systemd[1]: Failed to mount cgroup at /sys/fs/cgroup/systemd: No such file or directory [[0;1;31m!!!!!![0m] Failed to mount API filesystems. systemd[1]: Freezing execution. random: crng init done