connecting to NetworkSerialPort(target=Target(name='imx28-duckbill-0', env=None), name='NetworkSerialPort', state=, avail=True, host='moxa.cuskci.stw.pengutronix.de', port=4014, speed=115200, protocol='rfc2217') calling microcom -s 115200 -t moxa.cuskci.stw.pengutronix.de:4014 connected to 10.8.254.5 (port 4014) Escape character: Ctrl-\ Type the escape character to get to the prompt. HTLLCLLC barebox 2020.05.0-00003-g4c4057edd6 #6 Fri May 29 14:12:02 CEST 2020 Board: I2SE Duckbill detected i.MX28 revision 1.2 mdio_bus: miibus0: probed eth0: got preset MAC address: 00:04:9f:06:00:04 mxs_mci 80010000.spi@80010000.of: registered as mci0 mci0: detected SD card version 2.0 mci0: registered disk0 malloc space: 0x43efdac0 -> 0x47dfb57f (size 63 MiB) [?25h Hit m for menu or any to stop autoboot: 3 [1;32mbarebox@[1;36mI2SE Duckbill:/[0m bootm -v -r /mnt/tftp/1002001/tftp-deploy-hp0ntblo/ramdisk/ramdisk.cpio.gz -o /mnt/tftp/1002001/tftp-deploy-hp0ntblo/dtb/imx28-duckbill.dtb /mnt/tftp/1002001/tftp-deploy-hp0ntblo/kernel/zImage [1;32mbarebox@[1;36mI2SE Duckbill:/[0m bootm -v -r /mnt/tftp/1002001/tftp-deploy-hp0ntblo/ramdisk/ramdisk.cpio.gz -o /mnt/tftp/1002001/tftp-deploy-hp0ntblo/dtb/imx28-duckbill.dtb /mnt/tftp/1002001/tftp-deploy-hp0ntblo/kernel/zImage eth0: 10Mbps half duplex link detected T T T T T T T T T T T T T T T T T T T T mount: No such file or directory running automount command 'ifup -a && mount -t tftp $global.net.server /mnt/tftp' failed could not open /mnt/tftp/1002001/tftp-deploy-hp0ntblo/kernel/zImage: No such device handler failed with: No such device [1;32mbarebox@[1;36mI2SE Duckbill:/[0m