Trying 10.1.1.35... Connected to potato3.baylibre. Escape character is '^]'. U-Boot SPL 2019.07 (Oct 24 2019 - 12:03:12 +0200) DRAM: 2048 MiB Trying to boot from MMC1 NOTICE: BL31: v2.1(release):v2.1-841-g19adcb41 NOTICE: BL31: Built : 14:39:20, Oct 17 2019 NOTICE: BL31: Detected Allwinner H5 SoC (1718) NOTICE: BL31: Found U-Boot DTB at 0x4089250, model: Libre Computer Board ALL-H3-CC H5 NOTICE: BL31: PMIC: Defaulting to PortL GPIO according to H5 reference design. U-Boot 2019.07 (Oct 24 2019 - 12:03:12 +0200) Allwinner Technology CPU: Allwinner H5 (SUN50I) Model: Libre Computer Board ALL-H3-CC H5 DRAM: 2 GiB MMC: mmc@1c0f000: 0, mmc@1c11000: 1 Loading Environment from FAT... Card did not respond to voltage select! In: serial Out: serial Err: serial Net: phy interface0 eth0: ethernet@1c30000 starting USB... Bus usb@1c1b000: USB EHCI 1.00 Bus usb@1c1b400: USB OHCI 1.0 Bus usb@1c1c000: USB EHCI 1.00 Bus usb@1c1c400: USB OHCI 1.0 Bus usb@1c1d000: USB EHCI 1.00 Bus usb@1c1d400: USB OHCI 1.0 scanning bus usb@1c1b000 for devices... 1 USB Device(s) found scanning bus usb@1c1b400 for devices... 1 USB Device(s) found scanning bus usb@1c1c000 for devices... 1 USB Device(s) found scanning bus usb@1c1c400 for devices... 1 USB Device(s) found scanning bus usb@1c1d000 for devices... 1 USB Device(s) found scanning bus usb@1c1d400 for devices... 1 USB Device(s) found scanning usb for storage devices... 0 Storage Device(s) found Hit any key to stop autoboot: 2  0 => setenv autoload no setenv autoload no => setenv initrd_high 0xffffffffffffffff setenv initrd_high 0xffffffffffffffff => setenv fdt_high 0xffffffff setenv fdt_high 0xffffffff => dhcp dhcp ethernet@1c30000 Waiting for PHY auto negotiation to complete......... TIMEOUT ! BOOTP broadcast 1