connecting to NetworkSerialPort(target=Target(name='meson-g12b-s922x-khadas-vim3', env=None), name='USBSerialPort', state=, avail=True, host='nuc-2', port=36631, speed=115200, protocol='rfc2217') calling microcom -s 115200 -t nuc-2:36631 connected to 192.168.0.2 (port 36631) Escape character: Ctrl-\ Type the escape character to get to the prompt. G12B:BL:6e7c85:2a3b91;FEAT:E0F83180:402000;POC:F;RCY:0;EMMC:0;READ:0;CHK:1F;READ:0;0. bl2_stage_init 0x01 bl2_stage_init 0x81 hw id: 0x0000 - pwm id 0x01 bl2_stage_init 0xc1 bl2_stage_init 0x02 L0:00000000 L1:20000703 L2:00008067 L3:14000000 B2:00402000 B1:e0f83180 TE: 249614 BL2 Built : 16:01:39, May 25 2020. g12b gb6bfa83 - gongwei.chen@droid11-sz Board ID = 8 Set A53 clk to 24M Set A73 clk to 24M Set clk81 to 24M A53 clk: 1200 MHz A73 clk: 1200 MHz CLK81: 166.6M smccc: 000417f2 eMMC boot @ 1 sw8 s board id: 8 Load FIP HDR DDR from eMMC, src: 0x00010200, des: 0xfffd0000, size: 0x00004000, part: 1 Get wrong ddr fw magic! Error!! fw parse done PIEI prepare done 00000000 emmc switch 2 ok 00000000 emmc switch 0 ok NO find ddr boot_info from eMMC fastboot data verify result: 255 Cfg max: 12, cur: 1. Board id: 255. Force loop cfg LPDDR4 probe LPDDR4_PHY_V_0_1_22-Built : 16:01:44, May 25 2020. g12b gb6bfa83 - gongwei.chen@droid11-sz ddr clk to 1608MHz 00000000 emmc switch 1 ok dmc_version 0001 Check phy result INFO : End of CA training INFO : End of initialization INFO : Training has run successfully! Check phy result INFO : End of initialization INFO : End of read enable training INFO : End of fine write leveling INFO : End of read dq deskew training INFO : End of MPR read delay center optimization INFO : End of Write leveling coarse delay INFO : End of read delay center optimization INFO : Training has run successfully! Check phy result INFO : End of initialization INFO : End of MPR read delay center optimization INFO : End of write delay center optimization INFO : End of read delay center optimization INFO : End of max read latency training INFO : Training has run successfully! 1D training succeed Check phy result INFO : End of initialization INFO : End of 2D read delay Voltage center optimization INFO : End of 2D read delay Voltage center optimization INFO : End of 2D write delay Voltage center optimization INFO : End of 2D write delay Voltage center optimization INFO : Training has run successfully! soc_vref_reg_value 0x 00000026 00000027 00000026 00000026 00000027 00000026 00000028 00000028 00000027 00000026 00000027 00000026 00000026 00000024 00000026 00000026 00000028 00000027 00000029 00000028 00000027 00000027 00000027 00000027 00000028 00000028 00000027 00000028 00000027 00000027 00000027 00000028 dwc_ddrphy_apb_wr((0<<20)|(2<<16)|(0<<12)|(0xb0):0004 dram_vref_reg_value 0x 00000013 2D training succeed auto size-- 65535DDR cs0 size: 2048MB DDR cs1 size: 2048MB DMC_DDR_CTRL: 00e00024DDR size: 3928MB cs0 DataBus test pass cs1 DataBus test pass cs0 AddrBus test pass cs1 AddrBus test pass non-sec scramble use zero key ddr scramble enabled 100bdlr_step_size ps== 414 result report boot times 0Enable ddr reg access 00000000 emmc switch 3 ok BL2: rpmb counter: 0x00000000 00000000 emmc switch 1 ok Load FIP HDR from eMMC, src: 0x00010200, des: 0x01700000, size: 0x00004000, part: 1 Load BL3X from eMMC, src: 0x00078200, des: 0x01768000, size: 0x000ab200, part: 1 0.0;M3 CHK:0;cm4_sp_mode 0 [Image: g12b_v1.1.3394-7d43064d5 2020-05-07 15:37:11 gongwei.chen@droid11-sz] OPS=0x10 ring efuse init chipver efuse init 29 0b 10 00 01 1f 23 00 00 02 37 30 4e 42 4e 50 [0.016082 Inits done] secure task start! high task start! low task start! run into bl31 NOTICE: BL31: v1.3(release):d9e1bbe85 NOTICE: BL31: Built : 19:07:43, Sep 7 2020 NOTICE: BL31: G12A normal boot! NOTICE: BL31: BL33 decompress pass ERROR: Error initializing runtime service opteed_fast U-Boot 2021.01-00035-gde44e287b6 (Feb 02 2021 - 18:02:13 +0100) khadas-vim3 Model: Khadas VIM3 SoC: Amlogic Meson G12B (A311D) Revision 29:b (10:2) DRAM: 3.8 GiB MMC: sd@ffe03000: 0, sd@ffe05000: 1, mmc@ffe07000: 2 Loading Environment from MMC... *** Warning - bad CRC, using default environment In: serial@3000 Out: serial@3000 Err: serial@3000 Net: eth0: ethernet@ff3f0000 Verify GPT: success! switch to partitions #0, OK mmc2(part 0) is current device MMC read: dev # 2, block # 1024, count 4096 ... 4096 blocks read: OK There is no valid bmp file at the given address Hit any key to stop autoboot: 2  0 => setenv autoload no => setenv initrd_high 0xffffffff => setenv fdt_high 0xffffffff => dhcp Speed: 100, full duplex BOOTP broadcast 1 DHCP client bound to address 192.168.0.114 (8 ms) => setenv serverip 192.168.0.2 => tftp 0x1080000 3895222/tftp-deploy-ccb8i6sz/kernel/Image Speed: 100, full duplex Using ethernet@ff3f0000 device TFTP from server 192.168.0.2; our IP address is 192.168.0.114 Filename '3895222/tftp-deploy-ccb8i6sz/kernel/Image'. Load address: 0x1080000 Loading: *################################################################# ###############T #T ################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# #########T ######################################################## ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################### TFTP error: trying to overwrite reserved memory... => �I