Trying 127.0.0.1... Connected to 127.0.0.1. Escape character is '^]'. [ 0.000155] NOTICE: BL2: RZ G2M Initial Program Loader(CA57) [ 0.004418] NOTICE: BL2: Initial Program Loader(Rev.1.0.23) [ 0.010033] NOTICE: BL2: PRR is RZG G2M Ver.1.1 / Ver.1.2 [ 0.015486] NOTICE: BL2: Board is HiHope RZ/G2M Rev.1.0 [ 0.020749] NOTICE: BL2: Boot device is QSPI Flash(40MHz) [ 0.026189] NOTICE: BL2: LCM state is CM [ 0.030171] NOTICE: BL2: DDR3200(rev.0.34) [ 0.041714] NOTICE: BL2: [COLD_BOOT] [ 0.047865] NOTICE: BL2: DRAM Split is 2ch [ 0.050559] NOTICE: BL2: QoS is default setting(rev.0.17) [ 0.056003] NOTICE: BL2: DRAM refresh interval 1.95 usec [ 0.061422] NOTICE: BL2: v1.5(release):7f126e2-dirty [ 0.066371] NOTICE: BL2: Built : 12:29:04, Jun 24 2019 [ 0.071559] NOTICE: BL2: Normal boot [ 0.075204] NOTICE: BL2: dst=0xe631fd00 src=0x8180000 len=512(0x200) [ 0.081687] NOTICE: BL2: dst=0x43f00000 src=0x8180400 len=6144(0x1800) [ 0.089415] NOTICE: BL2: dst=0x44000000 src=0x81c0000 len=65536(0x10000) [ 0.108334] NOTICE: BL2: dst=0x50000000 src=0x8300000 len=1048576(0x100000) [ 0.328594] NOTICE: BL2: Booting BL31 U-Boot 2018.09 (Jul 02 2019 - 14:17:12 +0000) CPU: Renesas Electronics R8A774A1 rev 1.1/rev 1.2 Model: Hoperun Technology HiHope RZ/G2M platform (hihope-rzg2m) DRAM: 3.9 GiB Bank #0: 0x048000000 - 0x0bfffffff, 1.9 GiB Bank #1: 0x600000000 - 0x67fffffff, 2 GiB MMC: sd@ee100000: 0, sd@ee160000: 1 Loading Environment from MMC... communication out of sync communication out of sync communication out of sync communication out of sync OK In: serial@e6e88000 Out: serial@e6e88000 Err: serial@e6e88000 Net: eth0: ethernet@e6800000 Hit any key to stop autoboot: 2  0 => setenv autoloasetenv autoloa